I figure if I'm going to build a game room, I might as well start with my favorite game.  Over the years, I've collected a few pieces and parts to a Scramble cabinet, but still have a long way to go. 

Here's what I need:

19" Monitor



Sept 12, 2009
Here's what I have so far:

1 Scramble Cabinet

(condition:  beat-up and painted an ugly gray.  When I aquired it, I tried stripping the gray paint off with mixed results.  At least I have a template of the graphic if I choose to repaint it.  The wiring harness inside and the coin door seem to be intact as well)

1 Glass painted bezal

(condition:  Like the cabinet, has seen better days, but most of the artwork is in tact)

3 Control Panels

(condition:  All 3 are functional.  The CP on the cabinet has most of the CPO removed.  The 2nd Scramble CP I have has most of the overlay in tact (see below)



As an alternative, I do have a Super Cobra CP that would work as well (see below)



Sept 18, 2009:
Scramble Board and Marquee arrive from KLOV Member, MikeSandwick - thanks Mike.




Sept 19 & 20, 2009:
Covered cabinet sideart with painter's masking tape and then painted cabinet back to the original yellow (or close enough)

Blue masking tape applied to the STERN sideart	Cabinet painted Sun Yellow and masking tape is removed

I know..I know..i painted the T-molding, but I need to replace it anyway, so I wasn't too worried about it.

Sept 27, 2009:
Taped week-old yellow paint in order to paint in the stenciled "STERN" sideart.



The cabinet is by no means perfect but it at least looks like a scramble cab!  Just waiting to fix the harness (which I just recently noticed that the actual 36pin connector has been snipped off) and I await the correct monitor for this cab.

Oct 16, 2009
Restoration of power block:



Now to install the Power Supply Board



And power is in place.   Next is the harness edge connector.